This is an old revision of the document!
New Workstation Setup
These are the general steps for pre-configuring a new Clippership workstation on an existing Clippership network installation. Note that configurations vary, based on the requirements of the shipper.
- Map required network drive(s), ensuring the same path to the Clippership directory as other existing workstations
- Configure any required ODBC data sources
- 32-bit data sources required
- If this a Kewill.Integrate (KI) interface, install current version of Kewill.Integrate
- If you don't know, contact LSE support
- Kewill.Integrate installation info: Kewill.Integrate Installation
- If an OzExe integration, copy local folder that contains the custom exe file that launches your Clippership integration
- The shortcut used to start Clippership should help you locate this folder
- Usually C:\Logic or C:\ProgramData\Logic
- Run Clippership manually by running CSWIN.EXE from the network drive
- Important: Make sure you are running this from the same path as other workstations, i.e. F:\Clippership\CSWIN.EXE
- This will initiate the installation of prerequisite software such as C++ runtime files and .NET Framework
- Note: Due to how Windows handles mapped drives and admin elevation, you will probably run into file access errors if you log in to Clippership while elevated. So, we recommend clicking Cancel at the login prompt, and then starting again. Clippership should not prompt for elevation after its requisites are installed.
- Contact LSE support for remaining instructions, based on your company's configuration