This is an old revision of the document!
New Workstation Setup
These are the general steps for pre-configuring a new Clippership workstation on an existing Clippership network installation. Note that configurations vary, based on the requirements of the shipper.
- Map required network drive(s), ensuring the same path to the Clippership directory as other existing workstations
- Configure any required ODBC data sources
- 32-bit data sources required
- If this a Kewill.Integrate (KI) interface, install current version of Kewill.Integrate
- If you don't know, contact LSE support
- Kewill.Integrate installation info: Kewill.Integrate Installation
- If an OzExe integration, copy local folder that contains the custom exe file that launches your Clippership integration
- The shortcut used to start Clippership should help you locate this folder
- Usually C:\Logic or C:\ProgramData\Logic
- Run Clippership manually by running CSWIN.EXE from the network drive
- Important: Make sure you are running this from the same path as other workstations, i.e. F:\Clippership\CSWIN.EXE
- This will initiate the installation of prerequisite software such as C++ runtime files and .NET Framework
- Contact LSE support for remaining instructions, based on your company's configuration